About a week ago my TV's red convergence got screwed up. It only goes about 3/4 the way across the screen and is curled at the edge that is at 3/4 across. Most times when you turn it on, when it's been cooled off, it will start up ok. Then about 10 seconds after it's on the red goofs up again. I thought that the lens was loose and that's why it's distorted, but the lens looks fine. Any ideas? Heath
hedog, Please did you get an answer tou your question. I just started having a similar problem 2 weeks ago. My TV jurves at the ends just as you describe and all colors are separated. If can respond directly to my email ezoby@comcast.net thx -Zoby
I have a convergence problem with the HD1080...the center of the screen is ok, but as you move out from center the red seperates dramatically from the blue. How can I adjust this, or must I call a repairman? Is it a board problem, or is it the adjusting rings like on the back of computer monitor CRTs which by rotating them you can adjust convergence of the Red/Blue/Green???? I think the screen is 42" or so. In a rental unit and do not own this hard to look at piece of junk. Can not find a manual anywhere in the house either. Any suggestions (be kind...) Thanks.
