mmds no sound on some chans

hello all have no sound on rte1/2/tv3/tg4 since today did the usual rescan,power off/on
all the other chans seem to be fine(mmds southwest)anyone else experiencing the same.its a bit like the wife at times picture no sound..

 

i have same issue. just rte channels aswell. i am hesitant to do anything as i had same issue with sky movie channels earlier in the week i left them alone for a day and sound was back the following day. so im willing to wait to see what happens.

 

delete the channels and rescan, they should come back with sound

 

that worked for me. thanks.

 

cheers and thanks

 

what are correct codes for cork?

 

codes are not up for discussion on here if you the correct software on the box codes wont be an issue

 

tryed deleting the rte channells one by one and rescan no luck like the rest of you guys shall i leave it for a day or two

 

delte them all 1 by 1 then bbc should be channel 1 it is in my box go back in and do manual scan about 2 seconds and they be back but now they are at the very end of your tv listing.

 

Hi there, had the same issue with loss of sound. Instead of leaving well enough alone i somehow managed to delete the factor settings and delete all the channels. Rescan finds nothing. i will try to contact the guy i got it from as he may be able to help. i would appreciate if any of your guys could point me in the right direction. i am on MMDS with a digivox T v03-3000T boot version 1. I assume i need to reload software or the like. Apologies if i am out of line or have broken some rules, but i'm not too technical in these matters. from reading the above posts i don't even kmow how to delete channels. I never thought i'd miss westlife so much.........

 

When deleting channels 1 by 1 make sure you delete any doubles of these
channels you may have from previous scans.Take note of which frequency
they are on,it will be either 234,000mhz or 218,000 depending on which area
you are in.Do a manual scan on that frequency and you should find them at
end of your channel list.Depending on signal strenght you might have to
rename them.

 

niar leaving it will make no difference still wont come back click on factory settings and delete all channels simple as that then install again turn key emu on if its the box-t or digivox t press menu type 1570 if its box-t 1004 for digivox not 100% sure on digivox one (the emu is always on with the eurovox)always rescan without split cables to avoid loss of channel id (example instead of rte1 you would get something like tv 4025)

 

do not mention westlife ha ha all u need to do is reflash the box is it an older digivoxt are newer they changedtuner in the new one is 3330 boot other wise stick with the original flash

 

mayoman if you follow my post to niar you will be ok if not comeback to us no prob

 

thanks jackoooh got it sorted much app

 

Hi Jack,

So let me get this straight
1. delete channels (i should be able to do this again)
2. for my digivox t, press menu
3. when the menu (installation, set up etc) appears then type 1570
4. turn on the emu
5. Rescan without split cable
6. Bobs your uncle.

Thanks for the guidance, i'll try it again this evening.

Alan

 

Do a full factory reset turn the box off then back on then do a new scan that will sort your problem out for you make sure when you are scanning you are not on a splitter on your cable

Dont forget to turn your emu back on MENU>SYSTEM INFO> OK >press 1004 on key pad job sorted

 

your welcome !

 

Sky movie channels gone now.
Any ideas?