Im having a couple of problems but I have been able to burn dvds. It takes over an hour to make a copy. What's wrong Here are some error messages Im getting a message about dma. I follow the promt, check the box and reboot. But I dont notice anything different. Where do I go to confirm dma is enabled? I have been saying 'no' and continuing with the burn of dvd. I have had success (4 copies) but sometimes I get the error message and/or it had taken 1 hour Help would be appreciated Thank you
When you get the pop-up message again, click "Yes". Restart your computer afterwards. Should you need additional guidance, a guide can be found here. Also, hold your burn down to 4X. http://my.afterdawn.com/alkohol/blog_entry.cfm/231/dmaissues
Stop Clickin no on and click yes and restart you pc. some times is good to remove the program and install it again..
Thank you for the help. The link was good. All my drives were dma enabled (because I had clicked 'yes' on the box. BUt because you dont see anything change, I didnt want to click on 'dont show this message again" because I thought I might need the message THey should say "the drive is now dma enabled" Thank you
It took almost 90 minutes to burn the disk. dma is enabled something is still wrong. any ideas? Im burning at maximum speed offered
Maceasar, You are creating a image for burning that was why it took so long. You only want to copy one dvd to another dvd right so you dont need to create a image...creating an image takes up a lot time...just simply copy to copy will do.
Im not making an image of the dvd I think it takes so long because the Maxell dvds are 16x Ill buy faster dvds from now on Thanks
To compensate for your substandard media, regulate your burn at 4X. It is also recommended to get better discs i.e. Verbatim or Taiyo Yuden. Anyway, try updating your firmware, and see if it gives you any good fortune. http://forum.rpc1.org/dl_firmware.php?download_id=2395
