Nero Error Message "No seek complete"

coolguy10 · Aug 22, 2006

Hey i am pretty new at this, and this site has helpped out a lot, but i have been getting an error message while the dvd is burning in nero. it says "No seek complete
E: optiarc DVD+/-RW
Burn processed failed at 4x"

This is usually a few minutes into the burn process. Any help would be great.

gwendolin · Aug 23, 2006

Heres a bit on that error

90% of the time this type of error message is caused by poor media, poor power to the recorder, or an optical head needing cleaning, or a drive needing to be serviced.

But it's only 90% of the time. On a rare occasion I've seen this caused by driver conflicts. Either from other software, or drivers for the IDE Controller.

Old firmware on the recorder - Go to the recorder MFG's website to obtain the latest firmware for your recorder. (You may be able to obtain it from this link as well: http://forum.rpc1.org/dl_all.php)

Poor media - Try more than one brand of media. For example: TDK, Verbatim, Imation, Yamaha, HP, etc.

Poor IDE cable or incorrect cable - For higher end recorders these days if you use the 40pin cable you can have all sorts of unusual symptoms. It would be best to use an ATA-133 80 wire cable.

Driver conflicts - If you have or had another CD recording software installed on your system, its drivers could be conflicting with our software. This is rare for this symptom, but it does occur. Uninstall any other recording software and make sure all its drivers have been removed with it. Then reinstall Nero and make sure to use the latest version we have posted on our website.

Defective recorder - The optical head on your recorder may need cleaning or servicing. Or it's possible the circuit board on your recorder has an open coil or blown diode or resistor. Any of these could cause the error. Only solution would be to send the drive in for service to the recorder manufacturer.

Last edited by cynthia : 4 Feb 2005 at 10:17 AM.

Click to expand...

I would post a Nero log so we can examine it in full, located here
Nero 6 history log location: Program Files>Ahead>Nero>NeroHistory.txt

Nero 7 history log location: Program Files>Nero>Nero 7>Core>NeroHistory.tx

Log in or Sign up

Nero Error Message "No seek complete"

coolguy10 Member

gwendolin Senior member

Share This Page

Log in or Sign up

Nero Error Message "No seek complete"

coolguy10 Member

gwendolin Senior member

Share This Page

Useful Searches