Not getting all channels Eurovox

Hi
I moved a eurovox 2008 from Ballyfermot (where it was working fine) to an apartment in Rathfarnam and I cant get all the channels. It has 13 TPs from Ballyer but the signal strenght on 7 of them flicks between 2 and 29 percent .what can I do to get all the channels ?

Thanks

 

will you send me a private message of your service provider and I will try and help you out.

KMAC

 

Kmac no need for pms the provider is more than likely N**.

 

Hi
the supplier in both cases is n*l

 

Are they both running on Cable or is one of them MMDS

 

Sorry both of them are cable

 

You can try this

Go to menu, config, clear data and then clear channel data. Then do a normal powerscan from 290.000 to 403.000 using symbol rate 6887 N*L

 

I've tried that . the ist time I got 7 tps the 2nd time I got only 1
I am begining to think it has something to do with the signal strenght but the n*l box works fine

 

Are you using it from a splitter or the main feed ?

Make sure your cable is plugged into the RF Socket and not the antenna port

Press Menu > User Installation > pin = 1004
And see what frequencies are in the list

This is what you should have below


291.000 Mhz 6.887 Maud QAM64
299.000 Mhz 6.887 Maud QAM64
307.000 Mhz 6.887 Maud QAM64
315.000 Mhz 6.887 Maud QAM64
323.000 Mhz 6.887 Maud QAM64
339.500 Mhz 6.887 Maud QAM64
347.500 Mhz 6.887 Maud QAM64
355.500 Mhz 6.887 Maud QAM64
363.500 Mhz 6.887 Maud QAM64
371.500 Mhz 6.887 Maud QAM64
379.500 Mhz 6.887 Maud QAM64
394.000 Mhz 6.887 Maud QAM64
402.000 Mhz 6.887 Maud QAM64

To add these go to menu,installation,user installation and use the on button guide to add frequencies ( Green / Channel Edit , Red / Add Freq ). Info button will name them as you like .

For any frequency that you want to manually scan you select it in your list first by pressing OK when it is highlighted, ( a tick will appear beside the one you select), then you press the blue button to manually scan that frequency.