hey peepz! what if i convert and burn avi that will play in some dvd players and not in others? Using Nero 6.6 ultra and nerovision express 2
there are plenty of reasons why certain dvds won't play in other players: 1. burning speeds: burn at 4x so there will be less writing errors (rule of thumb is to burn at half the rated speed of the disk--8X disk burn at 4x). 2. read manual for your stand alone player and use the disks that will play in your player. If your player is less than 2 yrs old then it should play the + or - R disks! I said SHOULD that's why you read the manual. 3. try booktyping your drive to DVd-ROM so it will make your +R disks more compatible to players. Read this: http://k-probe.com/bitsetting-booktype-faq.php 4. make sure that there are no finger prints or scratches on your disk that make it hard for the player to read the disk! 5. use good quality media (rule of thumb....buy the ones that are Made in Japan.) Verbatim is a top notch disk and is the only exception to this rule....some Verbatims are made in Taiwan and they are top notch! 6. and don't burn too close to the outer edge of the disk ..... which will make the disk unreadable! but using good media you will be able to burn close to the edge better than lesser quality media. Just in case I only burn no closer than 4400MB, so if you can set your programs to that, all the better! follow these little tips of the trade and you'll have better success! good luck. also read this: http://www.cdfreaks.com/print/article/113 why the +R media is better than the -R media if you converted your AVI files to DVD compliant files then the reasons above will explain why some DVDs will play certain players and not all ..... make them more compatible.... following the above advise should help.
