possible 3 steps to 1 ? Expert advice needed.

Discussion in 'DVD / BD-Rebuilder forum' started by jlg895, Jan 22, 2006.

  1. jlg895

    jlg895 Regular member

    Joined:
    Jun 16, 2004
    Messages:
    207
    Likes Received:
    0
    Trophy Points:
    26
    Ok normally for most of my dvds I analyse with shrink then encode and then it automatically burns with decryptor or nero. The majority of us know this but I would like to put it out there: is there a way to file with decryptor, rebuild with rebuilder, and then rip to dvd all in one step. shrink does it automatically and I do most of my compression recording in my sleep. Any input?
     
  2. Phantom69

    Phantom69 Regular member

    Joined:
    Apr 22, 2005
    Messages:
    1,235
    Likes Received:
    0
    Trophy Points:
    46
    huh. We all just use a on the fly decrypter such as AnyDVD with DVD Shrink or CloneDVD or Nero Recode and do it all in one step.
     
  3. mistyguam

    mistyguam Member

    Joined:
    Aug 14, 2005
    Messages:
    42
    Likes Received:
    0
    Trophy Points:
    16
    mostly everyone talks about the shrink and decry i have been using anydvd and clonedvd and honestly i get a good burn with no errors and no added trailers just straight to the movie.
    mostly everyone states no error or eroor burns, i'll be honest the only ones that turn out errors are the ones i burn @ 8x and not 4x.

    then again thats just my suggestion.

    hope u get an answer
     
  4. arniebear

    arniebear Active member

    Joined:
    Jan 2, 2005
    Messages:
    7,191
    Likes Received:
    0
    Trophy Points:
    96
    You can run AnyDVD in the background and choose the disk as your source, rip your file using RB and tell it to automatically burn the output ISO file with Decrypter.
     
  5. jlg895

    jlg895 Regular member

    Joined:
    Jun 16, 2004
    Messages:
    207
    Likes Received:
    0
    Trophy Points:
    26
    Thanks arniebear, I had forgotten the pro version of rebuilder that rips to an iso.
     
  6. arniebear

    arniebear Active member

    Joined:
    Jan 2, 2005
    Messages:
    7,191
    Likes Received:
    0
    Trophy Points:
    96
    Good luck, just remember to tell RB to create an ISO file along with the usual VTS, and then tell it automatically burn with Decrypter. It will also do this with ImgBurn if you have this program :)
     

Share This Page