power calibration error - need help

Discussion in 'CD-R' started by goote, Jan 16, 2003.

  1. goote

    goote Guest

    I installed a new CD burner - Benq 4012A 40X12X48. The firmware which is installed is: 1.GE

    I'm trying to use Nero 5.5 to burn CDRs and CDRWs, burnning starts and then I get an error message, initially the error is:

    "Power calibration error"

    I tried different CD-R and CD-RW brands (including High Speed) and also tried to change burning speed in Nero but nothing helped.

    any ideas? thanks!!!
     
    goote, Jan 16, 2003
    #1
  2. skylinedo

    skylinedo Member

    Joined:
    Jan 7, 2003
    Messages:
    9
    Likes Received:
    0
    Trophy Points:
    11
    I think your power supply may be underpowered to burn CD's at high speeds. Try lowering this speed and try it again. If you have devices such as SCSI cards/drives, 3d Accelerators, etc then you'll need a higher wattage power supply.
     
    skylinedo, Jan 21, 2003
    #2
  3. goote

    goote Guest

    Thanks, I Will try to lower the burning speed.
     
    goote, Jan 21, 2003
    #3

Share This Page