Power Location for Duo2SE

Discussion in 'PS2 - Hardware boot discussion' started by dreamzboy, Aug 22, 2005.

Thread Status:
Not open for further replies.
  1. dreamzboy

    dreamzboy Regular member

    Joined:
    Jul 14, 2005
    Messages:
    168
    Likes Received:
    0
    Trophy Points:
    26
    Does it matter if I solder the power joint suggested by the Duo2SE diagram or using the Matrix Infinity diagram? It should power the chip on just fine right?

    For some reason, my ps2 doesn't read back up games.
     
    dreamzboy, Aug 22, 2005
    #1
Thread Status:
Not open for further replies.

Share This Page