Okay, so I just got my X3LCD in the mail, and have been hard at work putting the thing in! I got it in, and turned on the system with just the HDD plugged in! I was able to get into the BIOS Screen, and enable the X3LCD, so it was all good! So I decided to put the Drive back in, and the HDD, and then screw it all back together! (Well, I can't really screw it back together, because it all doesn't line up anymore) Anyways, Now when I try to turn on the system, it goes on, then off, comes on again, then off again. Then it comes on one final time, and the LED on the eject is Blinking, and the DIP Switch has a RED LED instead of the usual BLUE! I've gotten this many times, and I'm still fiddling with it, trying to figure out what the problem could be! Any suggestions?! Thanks
Alright! After looking into this more... I found out that the system works fine with the LCD disconnected (like the wire disconnected from the chip!), but when it's plugged in, it gives me the flashing Red/Green Error! Do you think that I should just get it replaced?
