Problem with Xbox 360 Softmodding (VIA RAID Controller)

Discussion in 'Xbox - Software discussion' started by nommyynom, Feb 18, 2009.

Thread Status:
Not open for further replies.
  1. nommyynom

    nommyynom Member

    Joined:
    Feb 18, 2009
    Messages:
    56
    Likes Received:
    0
    Trophy Points:
    16
    Okay i have an Xbox 360 Professional with a Toshiba Samsung DVD-ROM Drive, the model is TS-H943.
    Also i have a VIA VT6421 RAID Controller and a VIA VT8237A RAID Controller apparentlyy ;/
    A SATA cable
    and the power lead and video lead are plugged into the Xbox 360 while the SATA cable is plugged into the back of the DVD Drive and then into the back of my VIA RAID Controller which is plugged into one of the PCI Buses.


    everything is fine and i have the firmware (extreme52, which i got off xbins FTP server and used "Xtreme Boot Maker V0.5.3 (RC3)") on my santek 4gb USB stick and i've enabled the USB Drive to load up in the drive priorities.

    So when i finaly let the USB load up into dos... NOTHING HAPPENS! :'(!
    all i see is the flashing underscore appear once, then carries on flashing forever just underneath where it was before.
    But i think now it just stays in the top left hand corner and carries on flashing.

    the xbox 360 is on and whirring away like none other but nothing seems to happen ;/
    i have tried so many different tutorials

    am i doing something wrong?
    thanks loadss guys!
    any advice is much appreciatedd! :)
     
    nommyynom, Feb 18, 2009
    #1
  2. creaky

    creaky Moderator Staff Member

    Joined:
    Jan 14, 2005
    Messages:
    27,900
    Likes Received:
    1
    Trophy Points:
    96
    Please look/post in the xbox 360 forum
     
    creaky, Feb 18, 2009
    #2
  3. nommyynom

    nommyynom Member

    Joined:
    Feb 18, 2009
    Messages:
    56
    Likes Received:
    0
    Trophy Points:
    16
    gahh my bad.
     
    nommyynom, Feb 19, 2009
    #3
Thread Status:
Not open for further replies.

Share This Page