1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

ps2 + duo3 ultra = no power

Discussion in 'PS2 - Hardware boot discussion' started by badday, Jan 23, 2010.

  1. badday

    badday Member

    Joined:
    Jan 23, 2010
    Messages:
    2
    Likes Received:
    0
    Trophy Points:
    11
    i have a ps2 slim,

    this is my motherboard revision (gho-37-11)

    http://www.duomodchip.com/english/install/duo3ultra/duo3ultra_v14_v16_1.jpg

    after installing the chip, i get no power indication whatsoever, no lights, no nothing.

    can anybody point me in the right direction for a fuse diagram, for this model?, or any other hints that might aide me in my adventures? i have taken my dmm to the power supply and it is fine, i expect it is a broken fuse in the mix.
     
  2. badday

    badday Member

    Joined:
    Jan 23, 2010
    Messages:
    2
    Likes Received:
    0
    Trophy Points:
    11
    well, i found a fuse guide for another slim model, i checked every ps & th labeled point on the board, and they all read .5 or less ohms, so they all look good, any one know where else i might look for issues? power supply reads 8.82 volts when plugged in to the board
     

Share This Page