pstwo won't spin cd's anymore

I was using cdloader to play a backup and left my pstwo on for a second and when i came back it was spinning the cd and froze
after restarting it i noticed it wouldn't spin cd's
then i opened it and there was this little chip under cd drives motor that smelled burnt

it turns on fine and goes to the memory card and everything but it won't spin cd's
i have playedbackups like this hundreds of times but now it won't work

can someone tell me what i can do

PS I DON'T USE A MODCHIP

 

Post a pic of the part that you think is burnt, its probably a blown fuse, and if you were using cd loader, did u have anything on the switched that make the ps2 think the lid is closed, if u did it could be the switch was damaged, give me more information and i will tell you how to sought the problem out.

 

here are some pics
i circled the part i think is burnt on both of them red





so what do you think i should do

 

can that chip be found anywhere

 

I dont have my ps2 open right now, so i cant check that pcb out, as far as i can remember, there was no chip on that board, it just connects the wires upto the motor, but i will have to check, when you rotate the motor does it rotate smoothly or is it there like crackling noises when your rotating it, and secondly have to checked all the fuses on the motherboard, if not i think you should get a multi meter and check all the fuses. The diagram link it below, once you have checked the fuses let me know, and are they and chips on that PCB where the motor is?
http://www.picsystems.net/imagenes_fuses/v12.jpg

 

I took a more closer look at your picture, and the switch at the back of the motherboard looks like its broken or something, take a close pic of it and post it, your problem probably lies there, that switch needs to work, when you close the lid that switch tells the ps2 the lids closed it it powers up the motor circuit, without it you cant do anything.

 

yes, you need to get that switch soldered back on

 

it can't be the switch because its not broken because i can feel it and when the lid goes down the laser moves into position but the cd still dosen't rotate

is it possible for the motor to burn out because the motor and that little board smeel burnt

 

guess its not a good picture but it sure does look like it, but looking again you laser looks burnt, look closely at the eye and see if its melted a little

 

its not it looks normal

 

do you think replacing both the motor and laser would fix the problem

the switch looks broken because i had black electrical tape on it but it still works

 

try replacing laser first

 

i found a complete unit of the laser and motor on ebay
think its worth it
27 bucks

 

check pm