I just installed my Qoob Pro yesterday. Can't get it to work properly. After redoing all my soldering I finally get the qoob bios screen to load. If I try qoob bios 1.0 I get black screen, but when I try 1.3 b or c I get the qoob bios screen.. If I try Bios 1.3b I get error Check Lid Wires. If I try 1.3c I get No Medium Found! Restart! The laser does not light up at all.. It moves and then stops.. If I take the qoob chip out of the harness and put the lid switch back the GC boots up fine like the day I got it and the laser comes on. I hope someone can help.. tia Mark
