Hi, Need help. I have a Superdish. Can somebody help me for Coolsat 7000 settings as after installing Ver 1.13 all the 3 satellites (110, 119 and 121) started working. But after 10 mins 121 started displaying message "No Signal". It still shows the EPG listings but no signal. I have tried rebooting and also have tried to set the dish settings but to no avail. It is showing No Signal. I even tried keeping at same channel for 30 mins. Please help.
Compare your keys on your box to the latest keys and see if they are the same. Somewhere to start. Also check and see what your signal strength is. If you look in the top right corner, you will see the satellite you are aimed at. There should be a number there. When autoscanning, you should match that number to the satellite you are scanning. eg. mine shows Bell Expressvu 91 - I then would scan 91W nimiq 1,3
Problem is that 121 was coming for 10 mins before it went off. 110 and 11 are coming fine. 121 is showing 70% level and 0% quality when I go to dish settings. What else can I try.
One mOre observation is that when I do a Auto channel search for 121, it does NOT show any signal for the transponder. This problem was not coming earlier. 110 AND 119 are coming fine, only theinternational programming satellite is throwing the problem.
i have a similar problem i have a coolsat 7000 and i get great signal and after a few minutes all of my signals from the two satellites goes down to about 30 to 40 and there is no quality at all. i try to suitch it to another room ( in which i have a coolsat 6000 that works wonderful) and it does the same thing. i read in a forum that is because the lnbf does not have enough energy for the 7000 but i dont tink that it is the problem becaue then the no one would use that receiver. and also if the 7000 would suck all the energy from my dish then my 6000 would not work wile the 7000 is on but it does work. im woundering if i maight have a defective receiver or what. i have been with this problem for over a month and still no answer. i am very disapointed at my 7000. but please amy advise or ideas will help thank you
I have the same issue. 2 6000's and 1 cuts out at times. I do know the wire is old from the dish to the box and I get a weaker signal. Something I have to replace soon. The receiver with the better signal gets me about 100 more channels too.
When both stbs are on you have LOW power to the lnbs. Also maybe a bad d switch, bad cables, loose cables, bad lnb. Lots of things to check
