Starview Box Problems

hi
i turned on my clone starview box last and nothing worked, when i put in standby mode instead of the clock showing i get ramdon numbers showing.I did try to reinstall the flash but i could not get it to work.Can anyone help or is the bos history???????

Thanks Tom

 

Sounds like a cap has gone. Have a look here http://forums.afterdawn.com/thread_view.cfm/531363#3216144 and use a 16V one the pic says 10V but it needs updating.

 

Im sorry
Im Lost Can you explain to me please

thanks Tom

 

Apologies I left the link out, its there now. I have to head for a while but the pic has all you need.

 

it say to remove cap 21 does this need to be replaced later by a new one?????

 

No just resolder


1.Remove the cap (c21) electrolytic near the ribbon on the psu board.
2.Boot the box , it should boot to on and function correctly , the psu will hum ignore it , just let it boot to ON ,then turn it back off.
3.Replace electrolytic cap (c11) 1000 mic @16v on the psu board , resolder (c21)
thats it done.

 

Thanks for all your help back up and running again

Thanks Tom

 

Good man