STARVIEW Dublin problem (after codes)

Hi all,

This is my first post here. I recently picked up a couple of Star View boxes (for myself & my father)

After entering the new codes (released last week) I'm still having problems. When I hover over a channel (beyond the usual unscrambled ones) I STILL get the bad or scrambled channel message.

I've double checked the new codes (in both lines 00 + 01) - they are correct. Yet my box is not updating.

I tried a fresh installation - ie auto tune to NTL - 39 channels were found after 100% search.

Am I missing something?!

Thanks in advance

 

did you turn the emu back on.

 

Apologies - I'm a bit of a newbie - Whats the emu?

 

go into the secret menu and the last option you will see is emu. if its off then the channels will remain scrambled.

 

Thanks - will give it a go...

 

No joy I'm afraid - turned the EMU on - same business.

Here's the current codes I have entered

(00)
3BD5B14A53E0716C
(01)
CBC9BBA11F39FF86

Tried another installation scan on the NTL network - now showing ZERO channels- ?!!

I'm lost!

 

did you press ok to save the keys that you entered.

 

Yes, they were already saved since last Friday when I entered them. I saved both lines - ie save when 00 is shown and when 01 are visible (to be safe!)

Still no signal / channels showing?!

 

you could try flashing the starview with version 3.00 firmware. when you have it on go into secret menu and press set default key. then reflash to 255 or 257 as the v3.00 causes channels to freeze.

 

Apologies again, I'm unfamiliar with flashing, do I need to download firmware and transfer it to the box or can I do it within the menu as a standalone operation?

 

you need to download the latest firmware version 3.00 and the gtrom loader v4.00. you will need a null modem cable to connect your starview to the pc.

 

hi there heres the codes for n*l ireland

go to menu on remote then go into perental control hold info button on remote enter pin 2004

highlight Nagravision press OK.
This is what you have to enter:
KEY 0 = 3b d5 b1 4a 53 e0 71 6c
KEY 1 = cb c9 bb a1 1f 39 ff 86

Remember to store this by pressing ok. Exit out back to scrambled channel and happy viewing. THESE CODES ARE ONLY FOR ntl

 

These codes are already inputted... and saved - still no channels found...?!

 

In dublin 00-d3 0c 85 16 7a 4d 2c d7
01-cb c9 bb a1 1f 39 ff 86 these are working for me 10.45
30/5/07

 

hi all. my first post. have been trying all evening to get ntl working. finally found des61 codes.confirm they are working.

 

them codes are working ok.

 

I understand they are correct, for some reson my box is still not unscrambling channels...!

History:

A fortnight ago, bought the box, install fine - all channels working fine... NTL change codes - re-enter new ones - turn EMU on...

NOTHING now...

 

Hey Sticker,

Where are u based?? My mate had the same problem and restored factory settings, installed 3.00 software and is working fine now. This might be of some help

 

I'm in Clonee, Dublin...

How do you restore factory settings and install version 3.0?

 

Apologies, missing this -

How do I proceed...?
Download firmware from where?
Then do I just bring the box to the PC and connect?
I would have thought a usb connection to the box would have been easier!

Sorry - new to me!