starview genuine wont stop updating?

hi wonder if some one can help. i re-flashed my box in may last year and its worked fine, then a couple of months ago it stopped. now when i switch the box on it has a blank screen and says INFO and data is being updated, it goes upto 180% then thats it it stays there with a black screen behind it. iv tried re-flashing it but it doesnt change anything? i would really appreciate it if some one could help. cheers

 

the new flashes that were all done around christmas do seem to take while to kick in...try it on s#y 2 or sports 2.

 

hi liver 05.it seems to me from reading your post that you need to update your firmware.there was a change at christmas.

 

ok cheers i didnt know that! ha. where do i down load the new firmware from and whats it called? cheers.

 

You'll get it in eamo's library, look under scouser, karl, malci, noely, desb etc's signatures. You need the cryptview 1.5.

 

i dont wanna sound to thick ere but how do you get into there libraries? cheers

 

Under my beach ball.

Hi Eva

 

ahh haa! got it, il try it out later, il let you know how i get on! thanx a lot guys.

 

Hi noely, you got much snow?

 

Theres a good bit up this way, & i have the flu to go with it

 

Oh poor you! Are you at home sick?

Try making a drink with freshly squeezed orange juice, a squirt of lemon juice, a spoon of honey and boiling water!

 

Hi,

Can anyone help, my genuine starview box has lost its channels. Is it a case of doing the same as above, if so which cryptstar do I use as I have downloaded it and have two versions core 257 and core 400.

Once I have updated it through the loader do I need to do anything else or will my channels be back again?

Cheers,
Leigh

 

When you say lost it's channels, have you tried a Factory re-set and fresh Installation, and rescan on your provider - As regards the Firmware if your box is not updating you can use either of those (It is the Latest for AU) for Starview 1, Core257 is for a clone box and Core400 is for a Genuine box, but the 257 is safe to use on your box if you have any doubt, don't forget to check and turn ON the key Emu.

 

its lost all channels which have the dollar sign next to them. My box is a genuine one so use the 400 file and do a re-scan and all should be working again?

Leigh

 

lol Where's the whiskey eva?

 

Yes do that - and when you have finished it, don't forget to turn ON the Key Emu. Are you sure that it is turned ON at the minute? just check it to make sure.

 

the key emu is definately on, I'll try the update now and let you know.

Cheers,
Leigh

 

When did you last update your box Leigh, is it recently?

 

I last updated quite a few months ago. I have installed the new update and everything is working again. Thanks for your help, another happy customer...

Leigh

 

Well done. yep it needed it then pleases your up and running.