Hi I have just bought a used starview pvr on eb*y and have tried setting it up. Downloaded latest firmware, full installation, parental ctrl etc. freeview channels working ok, but cannot unscramble the others. Comes up with message INFO SCRAMBLED OR BAD CHANNEL [T1]. Please help !!!! Raj
Jaysus, Karl .. your busy tonight helping out the helpless LOL, thought you would be down the Village on a bar stool!!!
press menu-ok-then key in 1570 nothing shows up on the screen it should take you to the cas menu emu to on last option
well you can try this courtesy of fergusb which clearly states the emu option 1 Go to menu first 7.now your in the main menu,,press 1570 on remote pad. 8.now your in the cas menu,press the down tab once,to go to emu and turn it on,exit three times to get back to screen and view channels
Hi Raj888 have a plough through this: Print this out, read it at least A FEW times before continuing. You can forget about EMU codes and 1570's with the SV PVR it AU's (Auto Updates). First, Very Important You may need to load the latest F/W (Firm Ware)v4.506 Oct, you may have FTA Firmware installed. v4.506 is in the 'eko.4shared' link below. To find your present Software version press Menu/System Setup/System Information. If it is not v4.506 goto the link at the end of this post, download and install it before continuing. SECOND Then make sure you are plugged into the correct socket at the back (one of the four together) marked up. NOT the antenna socket. The manual is wrong. THIRD Before doing a scan Goto Menu / Installation and make sure the (Cable Network Option) top item is set to your local provider if not correct it by using the right / Left arrow keys on your remote, then move down to Autoscan and wait till it has finished scanning. Fourth If channels are not clearing after a scan goto Menu / System Setup / (Press OK) when the Parental Control line in yellow is highlighted then press i then 2007, this should take you the the Cas System Menu. (You may need try this a few times to get your key press timing correct on the remote control but this will get you into the Cas Syatem Menu) If you can't get onto the Cas System Menu screen then you are doing something wrong so re-read it and keep trying. Fifth When you are on the Cas Menu Screen and with Nagravision 1,11 highlighted in Yellow Press OK, On the Provider ID Line select the same provider as earlier by using the left/right arrow buttons on remote then press the LAST (load default) button on your remote, then the OK button to (Store) wait for it to save then press exit, then make sure Autoupdate option is On (Bottom Item in Cas System Menu.) This is the equiv of the EMU, Exit out, Goto a scrambled channel and wait for update. Goto the TheBox PVR Folder for F/W and Documentation Folder for How too's http://eko.4shared.com/ jbvid
