Entering keys manualy works fine. Works with all firmware except 258 as known to have issue's with getting secret menu up also no need to scan/reset just follow instructions below To put keys in manualy do as follows. press menu press 1570. this takes you into secret menu Hit ok on nagravision and change both keys 0, and key 1 Make sure your cable provider is listed at top N** or t******t ect To change between the 2 keys highlight key number press right and left When key changed hit ok (To store) after each one (YOU MUST SAVE EACH KEY INDIVIDUALLY - I.E. AFTER CHANGING n** 00 MAKE SURE YOU SAVE BEFORE CHANGING n** 01 & SO ON) telewest 00 = 4A 56 C3 4E 55 FC CB 14 01 = 0B 0D FC 37 7E BF FE 13 EX cable&wireless 00 = 1F EE 87 F9 E3 FA 2A AB 01 = EC 05 9C B0 3B 95 A2 A7 ntl 00 = D5 68 00 5A 29 36 51 D1 01 = E4 87 54 Df 4D 01 EC BA NTL Ireland keys KEY 0 = 3B D5 B1 4A 53 E0 71 6C KEY 1 = CB C9 BB A1 1F 39 FF 86 If done full factory reset/scan dont forget to turn on EMU >> DO NOT PRESS SET DEFAULT KEY OR WILL RESET KEY CHANGE ABOVE << Now exit and all channels ok On the starview remote: Pause button = Letter A Audio button(next to pause!) = B Red(sub) button = C Green(next to Red!) = D Yellow = E Blue = F To enter numbers use the numbers on the remote 0-9. To move left or right use the navigation buttons left and right. To confirm press ok.
