"Switch drive Power Off then On - ONCE."

In the jungleflasher guide for flashing liteon 83850c in the erase section it says switch drive Power Off then On - ONCE." How do you go about doing this if your powering from xbox? Does that mean you pull out the power cord then put it back in again? Im a bit confused over these instructions.

~Mistatic

 

You answered your own question. Yes, pull out the power cord and connect it again.

 

Oh ok i just tried this and bricked my xbox 360 lol

 

That is because you need to be using a probe II or vampire with connect kit. Powering with a 360 is retarded and you need to be doing a full dump anyway. Cut traces and dump the firmware, solder back together.

 

When you press LO83 button, pull the power cord from the 360 drive and put it back within a second. It will then ask you to open the tray fully and click OK, then for some reason it asks you to power on half open again, This time just press OK instead of doing the half open tray trick and it should dump.