Firstly thanks for all the help and advice in this forum its been great over the past few months. Have updated my eurovox max v with new software recently.. everything ok apart from a few of the channels, signal does not seem to be strong enough..momentarily freezing.i.e picture still there but it scrambles briefly. I think it is this 8% signal problem,but maybe its not? but this is where I am confused. I've read back through all the threads but still having problems figuring it out. Is there anything I can do about it or iss it just a fault in the box? I've seen in the firmware update sticky that halfway down it talks about a image to solve the 8% problem... should i download this and will it help? Do I have to go through the whole firmware downloasd again or is it just this file? Thanks in dvance, cheers!
If it was an 8% problem you would have it on all channels. Have you tried it with the signal booster on? Menu, config, TV settings, booster at the bottom.
Yes I have the signal booster on. When I check the info bar on all the other channels its is 8% all right, its just that only some of the channels become "scrambled" for a brief moment, not all of them. Any suggestions? Thanks
have you tryed the 28/04 firmware? http://www.4shared.com/account/file/46035037/7357f537/UFL_MaxV_Kuro3_28_04_08_T.html
No I put the Kuro 18/04 firmware on as per the sticky on eurovox firmware updating above... I'll try that if you think it will help, I presume its the same process as before except different software... anything else i should know? Thanks
