the box super no signal problem

hi i have the box super and for the last cupple days it keeps saying no signal i have rescaned turned it of and back on from mains left it off for a while put all the codes in turned meu of and back on but still saying no signal has anyone got any ideas please help me thanks

 

Make sure your coaxial cable is in CABLE INPUT at the back of the b0x.

 

Ok sounds like a signal issue from the providers.. is the normal TV working?.. if so then check that you have the connections in fully especially the scart lead, as sometimes they arent fully in!

 

yea it is it has been working fine for the last cupple months and now it just gone i have no idea have all the latest softwere btu still no signal is comming through :S

 

oops! how you Noel. I am Getting slow in the old age!! LOL

 

no signal usually means no signal,coaxial plugged into cable input,did u factory reset and autoscan again and emu to on,could also be a network down. do u have autoroll on ur box,try set default key-menu1570-set default key and exit,it should update to new info.

 

i too am getting old and slow lol

 

Hows things Des?
Could be a cc problem.

 

LOL, i think we`re all in the same boat

 

done factory reset again and rescanned found 14 chanels but no signal an eveythink else turned emu on and rescanned and still the same i have no ideas left

 

Did you try the cable in the back of the TV & see if you`re getting the basic channels?

 

sounds as if tps are down for repair.
if u factory reset first power off at back for a min/on and autoscan again correct provider? how many tps show in list when scanning?

 

Hi,

Sorry to but in but i am having the same trouble with my EX5000 (posted in another thread but no reply yet):

Still picking up no channels whatsoever. Swapped boxes with my mate (which works in his house) and his is the same here. Tried a 12db attenuator with a variable one but nothing. I can get the reminants of a picture on a couple of channels by fiddling with the variable attenuator but cant get anything anywhere near watchable. Had Verjin out and they kindly gave me a new box because the old one was taking forever to start up but said nothing wrong with the signal All channels fine on Verjin box.

On EVox my signal strength bounces up and down all the time between 80 and 85 then 8 for a split second (without the attenuators). With attenuators, when I get it to bounce between 72-75 a still blocky picture appears, then it disappears and the no signal message appears... Was this happening with you???

(p.s. Mine worked fine for about 2 weeks before all channels went blocky then "no or bad signal")

 

i dont know what i have just done but i have got all the channels back just kept rescanning did it 8 times and still only came up with 14 channels so i came out the scanning screen and turned on to a movie chanel to see my signal strenth and they all working thanks for all your help i wish i could tell you how i got them on but i cant if i figur out how i did it i will post it up straight away thanks again

 

no sorry they gone again back to about 14 chanels i can watch

 

did u do what i posted above?

 

@ rabbit, Try what cactikid said, as a factory reset/autoscan should pick up missing TP`s.

 

how many tps u are getting,in irl 37 n*l

 

hi i have done ractory reset and still the same i on TW i am only getting 2 tps i cant figure this out at all

 

try scanning other providers and see