The Box t

Hi,
Can anybody assist, came home this evening and found all channels gone on the box t I have.based in north cork.
The version have is the Box T API:501e_E Boot Version 7.0 12 december 2007
Reception is through an aerial on the roof and again this is from ***rus
Any ideas???

 

im the same only rte 1,got it sorted last time off this site hang in there

 

Hi Lads

Im the same ere, in blesso only gettin rte 1
can anyone help?

 

i'm the same and have read a load of other threads and this is what i found.
if you upload the latest firmware using the serial to serial cable on your starview box-t and then scan the channels you may get it to work.
otherwise you will have to purchase the kryptview box which works on nagravision 3.
hope this helps

 

iraelite,
I think you need to do more research.What you have quoted is incorrect.

gLog

 

spot on Glog, to correct him- no box will work on N3.(Yet)

@ 07batty, if updateing your firmware does not work, manually enter the newest 'Kxxx' needed for it to work!

 

Well guys i entered the new Kxxx manually and still no joy.Box-T by the way..tried flashing the lot...

 

make sure key emu is on after you have entered and SAVED the k. also when the cas menu is accessed the provider id that you will see is 5401 for n**, scroll right till you get 5E01 for c****s then enter k and save

 

hi darst.i tried manual entering k-ys for my neighbour,doesnt work.tried everything.i think they did a little more than roll k-ys ?.

 

well all i can tell you is mine autorolled and is working fine. are you sure you entered them in proper provider id and saved them after entering, then check key emu is on.when you exit back to tv if data updating stays at 0% try turning box off atthr back for a minute then back on. it should work and worth a try

 

Hi go to fixya .com for codes for boxt cant post codes here.type in what your looking for.when you get codes go to menu type in 1570 go to nagravision make sure provider is chorus and the emu is switched on then type in codes this worked for me in the last hour good luck

 

if u dont have the latest firmware on ur box,why do u expect it to work,everybody was told to update their box and now everybody in a panic,all tuts and firmwares in eamos library

 

thanks,got it sorted.

 

Just to clarify something, the Kryptview does not work on Nagra3, but it works on Nagra2 which is what is being used at the moment before a full migration to Nagra3.