I am trying to edit scenes from a movie but i can't move the source range. The picture stays on the first image in the movie. I tried to edit a little and the sound worked but the first image is what stayed on the entire time. It is an AVI file. Any suggestions? Thanks, chicago_animal
I did what I read in the forums about using virtualdub: 1. Click Video - Direct Stream Copy. 2. Click Audio - Full Processing Mode. 3. Click Audio - Compression. Select <No compression (PCM)> and click ok! 4. Click File - Save AVI and try it with TMPGEnc. The video that it is creating was only in 5 minutes and is over 1 GIG! ANyone know whats up?
Are you sure that you had the Video on "Direct Stream Copy" ??? Because if you have it on Full Processing mode and don"t choose a Codec it will just decompress the Video which can take up to 1gb per Minute.... Uncompressed audio takes about 1gb per 90 minutes at 48000hz, so your Typical 700mb DivX/XviD AVI file would turn into about 1.5gb after decompressing the audio...It takes about 6 minutes to Decompress the audio in a Typical 700mb Movie on my 2.5ghz P-4.... Cheers
