Updating firmware

Discussion in 'Nero discussion' started by anniebee, Nov 23, 2006.

  1. anniebee

    anniebee Member

    Joined:
    Apr 7, 2006
    Messages:
    48
    Likes Received:
    0
    Trophy Points:
    16
    Didn´t want to add this to my fairy liquid post.

    When updating firmware (once one decides to do it)after having located what you need and you press on "Flash Utility" what happens then?????

    Annie
     
    anniebee, Nov 23, 2006
    #1
  2. Ripper

    Ripper Active member

    Joined:
    Feb 20, 2006
    Messages:
    4,697
    Likes Received:
    13
    Trophy Points:
    68
    After you flash it, not much will happen for a few mins (longer than 5 and you're screwed, usually), then it will say flash complete or sumthing and reboot your PC on your say.
     
    Ripper, Nov 23, 2006
    #2
  3. anniebee

    anniebee Member

    Joined:
    Apr 7, 2006
    Messages:
    48
    Likes Received:
    0
    Trophy Points:
    16
    Dearest Ripper,

    So after I press "flash utility" if nothing happens I´m screwed????

    Annie
     
    anniebee, Nov 23, 2006
    #3
  4. Ripper

    Ripper Active member

    Joined:
    Feb 20, 2006
    Messages:
    4,697
    Likes Received:
    13
    Trophy Points:
    68
    No. You need to give it a few mins. As long as there is noting in your drive and nothing is running apart from the flash utiltiy; then it's perfectly fine/safe to do :)

    A bad flash only occurs wehn you don't follow people advice :p
     
    Ripper, Nov 23, 2006
    #4

Share This Page