Updating my starview to auto rolling firmware

Hiya

for obvious reasons i want to get my starview updated to autorolling codes!! i have downloaded GTRom v4 and CryptStar-v14-Genuine and will pick up a null cable modem from maplin tomorrow.

i just want to know before i go out and do all this whether ive got a clone or not because i dont want a big fancy looking brick in the living room.

its a first generation starview 1, has along the top 7x25 vents, if looking from the front the its scarts on the back are on my right hand side and its soft ware is:

STAR VIEW
API ver: 2.55e_E
Boot ver: 7.0
22. July. 2006

Thanks a million

 

im in same boat would like to know if this is the starview 1 beofre i have a go at the codes etc

usually found in the past that during a scramble my box would get all of the new code bar 1 letter or number..

 

better to be safe than sorry u can put clonesafe on both genuines and clones as v.255 is a very old vers.if u put genuine update on a clone box u will get a doorstop.

 

Ver 2.55 was out way before clones cact so I would say its definitely a Gen 1

 

ok thanks
where can i download this clonesafe file
and is there a guide on here somewhere i can use
sorry for all the questions never updated the box before

 

re:scouser
are you sure?it says starview on the front but thats all i can tell you about it..

 

Starvi*w Updating Firmw@re : http://forums.afterdawn.com/thread_view.cfm/663923