I keep getting scrambled channel and when I put on the EMU I get updating I have put in the codes for N*L and TW but none of them work. When I go into the screen to put the codes in at the top its says N*L and my provider ID is 54 01. But when I scan channels I only get channels on the TW setting and when I search on the N*L setting I get failed and no channels are found. My provider is 54 01 and it says N*L at the top. I don’t know why my provider says N*L cus my intanet from TW and they the ones I am connected to I think. Or should I do a full factory reset before entering the codes; and would this mean I have to have firmware updates put on. When putting in the codes should the EMU be on or off. Or should this be put on just after the codes are entered And after putting in the codes I should I rescan. Plz Help Thank You
press menu press 1570. this takes you into secret menu Hit ok on nagravision and change both keys 0, and key 1 Make sure your cable provider is listed at top N** or t******t ect To change between the 2 keys highlight key number press right and left When key changed hit ok (To store) after each one.. (YOU MUST SAVE EACH KEY INDIVIDUALLY - I.E. AFTER CHANGING KEY 00 MAKE SURE YOU STORE BEFORE CHANGING KEY 01 (TO STORE PRESS OK) telewest 00 = 4A 56 C3 4E 55 FC CB 14 01 = 0B 0D FC 37 7E BF FE 13 EX cable&wireless 00 = 1F EE 87 F9 E3 FA 2A AB 01 = EC 05 9C B0 3B 95 A2 A7 ntl 00 = D5 68 00 5A 29 36 51 D1 01 = E4 87 54 Df 4D 01 EC BA NTL Ireland keys KEY 0 = 3B D5 B1 4A 53 E0 71 6C KEY 1 = CB C9 BB A1 1F 39 FF 86 If done full factory reset/scan dont forget to turn on EMU >> DO NOT PRESS SET DEFAULT KEY OR WILL RESET KEY CHANGE ABOVE << Now exit and all channels ok On the starview remote: Pause button = Letter A Audio button(next to pause!) = B Red(sub) button = C Green(next to Red!) = D Yellow = E Blue = F To enter numbers use the numbers on the remote 0-9. To move left or right use the navigation buttons left and right. To confirm press ok.
