i copied my wedding video from my camcorder to dvd-rw on my samsung dvd recorder,i finalized it so it would play on other machines,but when i put it into pc and run it in cybrerlink power dvd it won't play?????i have burned movies and copied movies b4 and they all play???!! any help
you drive on the pc is being picky.... try using a different brand of disk to record on...... use quality media made in Japan or use Verbatim! Here are other reasons why some players won't play disks: 1. burning speeds: burn at 4x so there will be less writing errors (rule of thumb is to burn at half the rated speed of the disk--8X disk burn at 4x). 2. read manual for your stand alone player and use the disks that will play in your player. If your player is less than 2 yrs old then it should play the + or - R disks! I said SHOULD that's why you read the manual. 3. try booktyping your drive to DVd-ROM so it will make your +R disks more compatible to players. Read this: http://k-probe.com/bitsetting-booktype-faq.php 4. make sure that there are no finger prints or scratches on your disk that make it hard for the player to read the disk! 5. use good quality media (rule of thumb....buy the ones that are Made in Japan.) Verbatim is a top notch disk and is the only exception to this rule....some Verbatims are made in Taiwan and they are top notch! 6. and don't burn too close to the outer edge of the disk ..... which will make the disk unreadable! but using good media you will be able to burn close to the edge better than lesser quality media. Just in case I only burn no closer than 4400MB, so if you can set your programs to that, all the better! 7. make sure you burn to the correct region....PAL or NTSC! follow these little tips of the trade and you'll have better success! good luck. also read this: http://www.cdfreaks.com/reviews/Why-DVDRW-is-superior-to-DVD-RW/ why the +R media is better than the -R media
