VBR Bias, Quality Prec, and VBR Passes... are they fine at defailt settings?

Discussion in 'DVD / BD-Rebuilder forum' started by -Marlin-, Sep 18, 2005.

  1. -Marlin-

    -Marlin- Regular member

    Joined:
    Jul 25, 2005
    Messages:
    90
    Likes Received:
    0
    Trophy Points:
    26
    Do these need to be changed for any reason? I have the guide for RB, but am looking for a bit more in depth explanation.

    I see that VBR Bias is set right now for a more consistent quality as opposed to giving banwidth or whatever to scenes that need more, and quality prec can give better results in colour blockiness or edge artifact... I get that much. But how does one know when to alter these and by how much?

    Also, I can't find the thread anymore on this board where the number of passes of CCE was discussed, as I am curious as to when there is no more benefit. I seem to recall it being 4 passes?
     
    -Marlin-, Sep 18, 2005
    #1
  2. squizzle

    squizzle Active member

    Joined:
    Apr 19, 2004
    Messages:
    2,271
    Likes Received:
    0
    Trophy Points:
    66
    I believe you're right about this, but I'm not 100% sure either.

    I did notice some artifacts when I first started using these programs, but I've been using the Undot AVISynth filter and since then I've seen none at all.
     
    squizzle, Sep 19, 2005
    #2
  3. -Marlin-

    -Marlin- Regular member

    Joined:
    Jul 25, 2005
    Messages:
    90
    Likes Received:
    0
    Trophy Points:
    26
    Hmmmm.... what an Undot AVISynth filter?
     
    -Marlin-, Sep 19, 2005
    #3
  4. squizzle

    squizzle Active member

    Joined:
    Apr 19, 2004
    Messages:
    2,271
    Likes Received:
    0
    Trophy Points:
    66
    squizzle, Sep 20, 2005
    #4

Share This Page