I just got done installing a viper gc extreme chip in my cube and i turned it on and the Viper GC Extreme Logo comes up when i push "B" to program i cant get cobra to load i have tried the USB on my laptop but it says "The Viper USB Adapter Was Detected, but cant communicate with a Viper GC or Viper GC Extreme Chip. Make Sure Dip Switch 2 is on (programming mode)and that the gc is turned on" i tried changing the switchs but that did not help i tried to make a ISO of the bios but i got a "File Read Error" then i made another disk like it said and i got a "Disk Read Error" on that disk. i downloaded cobra agian and tried to flash it with my laptop but still did not work i got the same error again so can some one please give me some ideas why this is not working right the solder points look good Thanks
