What is my SATA chipset and will it work for flashing my 360?

Discussion in 'Xbox 360 - Modding & Hacking' started by jaems, Jun 25, 2010.

  1. jaems

    jaems Member

    Joined:
    Jun 25, 2010
    Messages:
    2
    Likes Received:
    0
    Trophy Points:
    11
    jaems, Jun 25, 2010
    #1
  2. RastaDave

    RastaDave Regular member

    Joined:
    May 24, 2010
    Messages:
    269
    Likes Received:
    0
    Trophy Points:
    26
    You will need a compatible chipset . You can get a hold of a sata pci card I used a via 6421 . You also need portio32 driver and jungleflasher and finally the correct ixtreme firmware for your drive .
     
    RastaDave, Jun 25, 2010
    #2
  3. creaky

    creaky Moderator Staff Member

    Joined:
    Jan 14, 2005
    Messages:
    31,683
    Likes Received:
    1
    Trophy Points:
    96
    Thread teleported out of the old type xbox forums
     
    creaky, Jun 27, 2010
    #3
  4. lsd447

    lsd447 Member

    Joined:
    Mar 30, 2009
    Messages:
    85
    Likes Received:
    0
    Trophy Points:
    16
    Give it a go, wont hurt to test your own out, remember to change your Bios sata settings to IDE/native and plug in your AV cable to the xbox if your using it to power your drive whilst flashing, good luck.
     
    lsd447, Jun 27, 2010
    #4
  5. 360lifer

    360lifer Regular member

    Joined:
    Jun 17, 2009
    Messages:
    435
    Likes Received:
    0
    Trophy Points:
    26
    I got a nforce 5 board and yours is 4. Mine works fine so I'd give it a go.
     
    360lifer, Jun 27, 2010
    #5

Share This Page