What is this part?

Discussion in 'PS2 - Hardware boot discussion' started by heyiou, Jan 22, 2009.

  1. heyiou

    heyiou Member

    Joined:
    May 31, 2005
    Messages:
    4
    Likes Received:
    0
    Trophy Points:
    11
    I was installing a Duo 3 Ultra on a 77001 slim ps2. I messed up soldering on one part and when i tried to get some of the solder off i ended up getting the whole little chip off. It's points Q and T on this diagram. Is this a fuse? Where can I find one of these? If there arent available, can i just solder the points the would have connected (if fuse)? The unit still powers up and the disk spins, I'm hoping this is just a fuse to the bios and that I can just "jumper" where this chip was, or better yet replace it.

    [​IMG]
     
  2. heyiou

    heyiou Member

    Joined:
    May 31, 2005
    Messages:
    4
    Likes Received:
    0
    Trophy Points:
    11
    Looks like it may be a capacitor array right?
     
  3. heyiou

    heyiou Member

    Joined:
    May 31, 2005
    Messages:
    4
    Likes Received:
    0
    Trophy Points:
    11
    and if it is...which one do i need to replace it...i see sites with 680 pf capacitor arrays but then you need to know voltage and all that good stuff....anyone have a clue?
     
  4. heyiou

    heyiou Member

    Joined:
    May 31, 2005
    Messages:
    4
    Likes Received:
    0
    Trophy Points:
    11
    or i guess it could be a resistor array, but i would think either would be easy to find
     
  5. Stabby

    Stabby Regular member

    Joined:
    Nov 15, 2006
    Messages:
    179
    Likes Received:
    0
    Trophy Points:
    26
    If you need one, I have a few junk boards for parts. I can send you one if you like. Just pay postage and it's yours.
     

Share This Page