Hiya - Recently I've been getting this intermittent error while using CloneCD4 to burn CD-R's in a Sony DRU-500AX.... "Write To CD Failed, Unit Not Ready : Logical Unit Not Ready, Long Write In Progress (2:0X04: 0 X08)" No part of any other authoring prog is loaded, the media burns fine (when it works)and I can write to it with my Mitsumi CD-RW. Most recent example was an audio CD, but it's occurred with data too. Damned annoying, and my coaster collection is growing fast. Any ideas gratefully welcomed - Thanks!
Hiya Shoey, thanks for replying - Error occurs when writing from a CloneCD image. During the lead-in burn the drive speed seems to hunt up and down, and then that error message pops up at about the point where it should switch to burning the data. I read elsewhere that it could be an issue with poor media or poor recognition of media? So I tried writing the same image on same data at 4x - that worked. So I'm wondering if either the drive or CloneCD is reading the settings for the blanks (DataSafe Silver Premium 40x 80 min) and attempting unsuccessfully to write at a high speed? This might mean that when the program thinks it's time to shift to data-writing, the drive is actually only halfway through the lead-in (eg a long write is still in progress). I'm guessing here, as you might be able to tell.... ) Any idea or suggestions very appreciated. FWIW, blanks from the same pack *have* written successfully at high speeds previously. Cheers!
If it were me I would try Alcohol 120 and see if you're encountering the same errors to determine if this is a hardware issue m8. Shoey
