Alright, I just soldered the Xecuter 2.6 Wire Installation and now when I go to boot my xbox (v1.0) the fan starts to spin for 1 second and then there is nothing. When I was taking out the wire from the power supply to the mb I accidently pulled a wire out, but I was able to fit it back in. Any help on this issue would be great. P.S. The soldering isn't a great job, but it's not bad enough to effect the power.
Forget what I just said because I pulled out all the soldering on the LPC board and it started working again. Question. After I solder the correct wires to the LPC and the Hdd activity wire/D0/LED and hook it up to the chip is there supposed to be a specific way the chip lies because it is free to move around?
