xbox w/ duox2 chip won't boot into evolution x dash

Discussion in 'Xbox - Hardware mods' started by CopperKid, May 25, 2008.

Thread Status:
Not open for further replies.
  1. CopperKid

    CopperKid Regular member

    Joined:
    Aug 1, 2007
    Messages:
    816
    Likes Received:
    0
    Trophy Points:
    26
    It keeps on looping any suggestions?
    Thanks

    [edit] I got it fixed. I formatted the c:/ and e:/ drives then I used my good old AID 3.10 disk instead of the AID 4.20 disk and reinstalled EvoX and it's all good.

    I've done a little more research and apparently from what I've read there are some bad trainers on the AID 4.20 disk that cause the loop. If you delete the trainers using the aid disk after the install it will boot up the dashboard. So if anyone else has this problem that what you do and then you can ftp the trainers back.

    Does anyone know which specific trainer it is?
     
    Last edited: Jun 17, 2008
    CopperKid, May 25, 2008
    #1
Thread Status:
Not open for further replies.

Share This Page