xenium sp ice problem

Discussion in 'Xbox - Hardware boot discussion' started by gerryp, Aug 17, 2005.

  1. gerryp

    gerryp Member

    Joined:
    Aug 15, 2005
    Messages:
    5
    Likes Received:
    0
    Trophy Points:
    11
    hi,
    Received xenium sp ice from divineo. Have v1.0 xbox so installed just solderless adapter and chip. Cleaned and roughed up solder on LPC and attached loop wire to correct DO. When I turn on the xbox the chip glows red and it boots up to original Xbox screen, no xenium bios screen. Have instructions for Xenium Ice install and noticed that the solderless adapter in pic( which is blue mine is black) has a wire going from a pin (think its pin 4) to the wire loop that attaches to Do point, mine has no wire. Could this be problem? Kind of new at this, any help would be appreciated.
    Thanks
     
    gerryp, Aug 17, 2005
    #1
  2. ulvirys

    ulvirys Member

    Joined:
    Mar 26, 2005
    Messages:
    8
    Likes Received:
    0
    Trophy Points:
    11
    ulvirys, Aug 18, 2005
    #2
  3. gerryp

    gerryp Member

    Joined:
    Aug 15, 2005
    Messages:
    5
    Likes Received:
    0
    Trophy Points:
    11
    that's the guide I followed.
     
    gerryp, Aug 19, 2005
    #3

Share This Page