Any one can help me please

Discussion in 'Xbox - Hardware mods' started by sdlive, Apr 19, 2005.

  1. sdlive

    sdlive Member

    Joined:
    Apr 19, 2005
    Messages:
    6
    Likes Received:
    0
    Trophy Points:
    11
    hey my xbox is starting to piss me off. my LED blinks green and red. i have went over the solder points and they all look good and tight but i also burned off one of my pads but i fixed that but it still doesnt work. can one of you guys help me. and no i wont trow my xbox away. my mod chip lights up with the blue lights. and the switch does too but it comes up with a red light for disabled i guess.
     
  2. modster

    modster Regular member

    Joined:
    Oct 6, 2004
    Messages:
    782
    Likes Received:
    0
    Trophy Points:
    26
    check your hard drive and dvd rom ribbon cable and make sure that it is plugged in tight.
     
  3. sdlive

    sdlive Member

    Joined:
    Apr 19, 2005
    Messages:
    6
    Likes Received:
    0
    Trophy Points:
    11
    Ok I havd done that and it still doesnt work. it atcully turn on and off 2 times then the 3rd time it keeps going and the green/red like comes up. and like i said i have check over every thing and i cant see what going on.
     
  4. Molder

    Molder Regular member

    Joined:
    Sep 7, 2004
    Messages:
    319
    Likes Received:
    0
    Trophy Points:
    26
    sdlive,
    Did you just install the mod chip?

    Did you do anything out of the ordinary, eg change HD etc....

    Drop/kick the unit?

    Maybe the chip has spat the dummy!!

    M
     
  5. sdlive

    sdlive Member

    Joined:
    Apr 19, 2005
    Messages:
    6
    Likes Received:
    0
    Trophy Points:
    11
    well i think i figured the problem out i was looking at the stuff that came with the mod chip and the was the pin and the wire that had the pin on the end of them. well i noticed that the some of the pins were missing for the wire one and i think that could be causing a problem but i am going to work on that tomorrow. tell me if you think that could be a problem or not. thanks
     
  6. Molder

    Molder Regular member

    Joined:
    Sep 7, 2004
    Messages:
    319
    Likes Received:
    0
    Trophy Points:
    26

Share This Page