Connect JTAG and Power up EuroVox Start JKEYS Click on "Development Panel" Click OK to ingore the warning. ** SEE BELOW IF YOU GET AN ERROR HERE ** If all goes well you will get into the development panel. In the user functions box: Type in the address: 80000000 Click on "Load to . . ." Select the file "unlock_28FxxxC3.bin" Click "Trigger User" Close the current window. Click on "Flash Programming" Choose the model number as: DXD426RD (1 Chip-GLA) In the section on the right: Leave the box above set to "Full" Click "Erase" Select YES. This will take a minute to erase. Click on "Program" Select YES to "Program at address 0x7FE00000, size 0x200000?" Choose your TSOP file Sit and wait for OK to become active, then click it. Close JKEYS and power the box down. Disconnect your JTAG Power the box on. If all has gone well then it should boot up ready for you to rescan for your channels. *** If you get an error trying to get into the devleopment windows **** Power the box down and run SkyMax v2.2 Power the box up Press start. This seems to reset the box when JKEYS cannot connect (DCU errors). Close SkyMax and start JKEYS and try again. Personally I went with Skymax first and then jkeys as it seems to work better. SkyMax 2 http://www.mediafire.com/?8fzumnj1k9g Jkeys http://www.mediafire.com/?e9dyyzgn8q3 Max V TSOP http://www.mediafire.com/?5dd11z2djmw Use SunRise's method above for the INTEL chipset and the black tsop to bring your MaxV back to life. The usual SkyMax method will work for ST chipsets. I have had this working with the black tsop for the last couple of weeks on test. I was able to download the September critical update to the box so it is working fine.
Thanks ph0rce and as always youre welcome And I have deleted the narky end comment as that is that as we say.
