1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

DVD Drives loses properties settings

Discussion in 'DVDR' started by TWINMT, Mar 15, 2007.

  1. TWINMT

    TWINMT Member

    Joined:
    Apr 18, 2006
    Messages:
    2
    Likes Received:
    0
    Trophy Points:
    11
    My DVD Drives keep losing the property settings for recording and sometimes the drives don't even show when a DVD is inserted in them. So because of these problems I can't record.
    I have reset the proerty settings and reinstalled the DVD Drives but the settings don't hold. Does anyone know what is causing this and what I can do about it?
     
  2. LOCOENG

    LOCOENG Moderator Staff Member

    Joined:
    Feb 4, 2005
    Messages:
    11,493
    Likes Received:
    2
    Trophy Points:
    118
    What do you mean by property settings?

    Are you talking about the burn settings revert to default after closing and reopening your burning/decrypting software or is there something wrong with your drive in device manager?
     
  3. scorpNZ

    scorpNZ Active member

    Joined:
    Mar 23, 2005
    Messages:
    3,989
    Likes Received:
    40
    Trophy Points:
    78
    Check you have set up the dvd burners as master and slave do not use cable select,there should be a diagram on the top of the dvd drive case that shows where the bridge should be

    There should be no settings in properties to adjust unless you have purposely disabled one of the drives and you want to renable
     
    Last edited: Mar 15, 2007

Share This Page