1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

xenium ice (FRAG) I am a newbee and installed the chip as directed.

Discussion in 'Xbox - Hardware mods' started by mel1djm, Dec 7, 2004.

  1. mel1djm

    mel1djm Member

    Joined:
    Dec 7, 2004
    Messages:
    9
    Likes Received:
    0
    Trophy Points:
    11
    I am getting Flashing red and green on the eject button. I am using the soderless adapter. I cleaned the contact points with rubbing alcohol but still get the red and green flashing. I believe I have version 1.5 of the X-box. I saw a thread that stated I need to install the 2 extra wires that came with my kit. Should I be looking at the tv for more codes.

    Any help would be appreciated..

    Dave
     
  2. suki24

    suki24 Member

    Joined:
    Jun 11, 2004
    Messages:
    73
    Likes Received:
    0
    Trophy Points:
    16
    the official xenium chip site/forum would be more helpful...

    the problems I know that causes frags would be..

    1)bad contact points(pins)
    2)bad DO contact

    I serious do not recommended solderless...as it is very unreliable
     
  3. mel1djm

    mel1djm Member

    Joined:
    Dec 7, 2004
    Messages:
    9
    Likes Received:
    0
    Trophy Points:
    11
    Thanks for the reply! From everything I have read, it appears to be bad contacts. I will simply soder it..

    Dave
     

Share This Page