1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

ATI MB UTILITY DRIVER PROBLEMS for setting up sata

Discussion in 'PC hardware help' started by DLEE47, May 9, 2007.

  1. DLEE47

    DLEE47 Member

    Joined:
    May 9, 2007
    Messages:
    1
    Likes Received:
    0
    Trophy Points:
    11
    I have a customers pc I am building a ati rx480 mk7-64x motherboard and I have followed all directions for saving the sata non-raid files to diskette. I am going in loopes now because when I f6 in xp then s for mnfcture disk it says reading disk... then it goes to xp has a driver for si 8x12 or whatever it is now and if I say load default it tries to load xp and never finds a hd boot-up screen shows a serial drive present and when I try this over again and s then it starts over with there is already a drive utility loaded what next
     
  2. ffg7

    ffg7 Regular member

    Joined:
    Apr 20, 2007
    Messages:
    268
    Likes Received:
    5
    Trophy Points:
    28
    did you configure the bios so that the sata drive is the boot drive & not an ide drive?
     

Share This Page