My pioneer DVR-106D worked fine with TDK DVD+RW (assume 2.4x because without writing speed marked on the cover). When I used Imation DVD+RW(4x)and nero6 for burnng, the message "Burn process failed at 2.4x (3,312 KB/s)" appeared as follow. What should I do?
Nero version: 6.3.0.0 Recorder: <PIONEER DVD-RW DVR-106D>Version: 1.07 - HA 3 TA 0 - 6.3.0.0 Adapter driver: <> HA 3 Drive buffer : 2000kB ************************************************* Bus Type : default (0) -> ATAPI, detected: ? ************************************************* CD-ROM: <SONY DVD-ROM DDU220E >Version: 5.0i - HA 1 TA 1 - 6.3.0.0 Adapter driver: <IdeChnDr> HA 1 === Scsi-Device-Map === DiskPeripheral : HDS722580VLAT20 IdeChnDr Port 0 ID 0 DMA: On CdRomPeripheral : RICOH CD-R/RW MP7200A IdeChnDr Port 0 ID 1 DMA: Off DiskPeripheral : IC35L040AVER07-0 IdeChnDr Port 1 ID 0 DMA: On CdRomPeripheral : SONY DVD-ROM DDU220E IdeChnDr Port 1 ID 1 DMA: Off CdRomPeripheral : Generic DVD-ROM 1.0 d346prt Port 2 ID 0 DMA: Off **************************************** YOUR DMA IS NOT ON ???????????? **************************************** === CDRom-Device-Map === RICOH CD-R/RW MP7200A E: CDRom0 SONY DVD-ROM DDU220E F: CDRom1 Generic DVD-ROM H: CDRom2 PIONEER DVD-RW DVR-106D G: CDRom3 ======================= also i have hacked v1.08 firmware in mine! also after that lot try new nero! it make like those discs?
Rotary Thanks for your prompt reply ************************************************* Bus Type : default (0) -> ATAPI, detected: ? ************************************************* What does it means? **************************************** YOUR DMA IS NOT ON ???????????? **************************************** Is it because I did not insert the disc into the following CD/DVD drives? CdRomPeripheral : RICOH CD-R/RW MP7200A IdeChnDr Port 0 ID 1 DMA: Off CdRomPeripheral : SONY DVD-ROM DDU220E IdeChnDr Port 1 ID 1 DMA: Off CdRomPeripheral : Generic DVD-ROM 1.0 d346prt Port 2 ID 0 DMA: Off My pioneer DVR-106R was external drive and connected via USB. I have download V1.08 firmware. It was installed unsuccessfully and there was no disc in the DVD/RW. New nero means what version of nero?
hi there the ? next to atapi is not good! its like its not sure if its there? also dma is better for speed and reading / writing discs! go to device manager and change it to DMA on as it will be PIO. now your firmware i am not sure why its not gone in, but cant remeber the install process, is it original? or hacked? check website for install instructions do firmware last! as the above 2 are more important!