DBOX2 - Lost Channels

Use a aditional nullmodem cable for flashing and check the log output. All other things are only speculation.
You can get a nullmodem cable via ebay for 0.99 .

 

using a null modem cable and rs232 both conected to box

 

And what do you get in the log output?

 

had a message box come up in german and clicked ok button then nothing , have put in earlier post what it said

 

If you flash with nullmodem cable and crossover cable and you select flashing with nullmodem inside IFA you get a full side of messages in the IFA window after plug in the box.

 

it went through the motions of numbers and letters and a hole lot of other thing and last one said it was done
Sorry not very good at this

 

Post the last 10 lines from the IFA window.

 

sorry dont know how to ,dont even know if i saved it

 

What do you get now if you try to flash?

 

WILL TRY NOW BACK IN TEN MINUTES

 

If you see anything at all in the LCD then there's a chance you can restore the box with IFA. If there is nothing then the box is damaged, although I have never known this to happen just using IFA, did you use the correct image for your box?

 

Just tried again and this is what bottom 10 lines said
unprotected 63 sectors
dbox2-ppcboot>erase 10020000 107fffff
erase flash from 0x10020000 to 0x101ffffff
sector63 done
erased 63 sectors

dbox2-ppcboot>cp.1 120000 10020000 1f8000
copy flash
flashed 7mb
done
dbox2-ppcboot>

THEN THE MESSAGE IN GERMAN COMES UP and toPRESS OK

 

NOTHING HAPPENS AFTER THAT EXEPT IT SHUTS DOWN AND LEFT WITH MESSAGE4 ON TV SCREEN DBOXFLASHINGASSISTENT IS WORKING ON YOUR DBOX AND THAT HAS BEEN THERE FROM START

 

Close IFA, unplug the box wait a little bit and replug.
You should see something at the tv screen. The box need a few seconds for booting up.