eurovox 8% signal quality problem (8 percent)

hey guys

yh ive got the exact problem ive checked everything and still the same thing

is there going to be a fix for this

thanks

 

I've had the same issue since the start of the codes wouldn't update thing. I thought it was something NTHELL done. Must take a look at the cable later. Still thought, the channels work ok.

 

I still have the problem as well Pandoo its looking like my tuner is fuc**d and upgrading the firmware wanked it altogether

 

lool

i dont get this before this version i had the kuro 2 which worked superbly i got between 85-93% now i dont even get nowhere near that

 

Did you factory reset after you updated?

 

Yep, I tried that just there. Didn't work. Let it rescan the channels and it picked up 120 something rather than 138 that was there before. But still getting the 8%. Some of the channels are kinda choppy because of this. Ones like Animal planet.

 

hey

yes i did do a factory default like 3 times after the installation

do you think theres going to be a fix for this

 

can any 1 say for definate does this new upgrade work dont want to upload it if it is going to break it altogether.

 

The update works fine for me, autorolles in all. Just that before the update when the systems first started to not autoroll, my signal strength went to 8%. Then after the update it went the same.

 

hey guys

plz help i have had no luck still with the new firmware

its doing a great job updating but whats the point as i cannot view 3/4 of the channels as its stuck at 8%

please guys help me get a fix for this

ive done everything suggested so far

 

lads try this

to get rid of the "no transponder problem"

restore to factory settings, go into languages, press 1968, go to emm capture-enable it, press 1968, should get a table of providers, go to your provider set as default, exit, then do a full scan,

hopefully this will work.