eurovox max help

hello, all my channels are on 8%level,8%quality some of them are showing a perfect picture but most of them are scrammbling,freezing or have no signal i am in south dublin anyone have any ideas how to fix this

 

hi mate..

i had the exact same problem..all you have to do is update to the latest firmware here and everything is workin perfectly..it even supports widescreen format

http://forums.afterdawn.com/thread_view.cfm/578790

cheers

 

Is your scart in fully your coax from n.l in your" rf in "on the box, and lastly check and see if there is work going on in your area also you can check and see if your emulation is on by going into menu language settings(ok) press 1968 on your remote go down to emulation and make sure its set to enable

 

hello id reckon its the firmware i have the sept firm. thanks for the help

 

september critical update firmware is fine shouldnt have any probs with that

 

hello i tried to load the firmware onto the eurovox i have the null modem cable and the usb adapter but when i go to download ,it comes up com 3...and when i press start it says receiver not detected any help would be appreciated.

 

I take it you can see the usb in device manager?if so i had the same problem a few weeks back and i just disconnected everything and reconnected firmly,and the box was detected immediately.

 

hi mate.. i hope youve already downloaded the latest firmware this is what you have to do to get the usb adapter to work.. i had the same prob .

1. Go to the Start Menu
2. Right click on "My Computer"
3. Select "Properties"
4. Click on the "Hardware" tab
5. Click on "Device Manager"
6. Click the + sign next to "Ports (COM & LPT)"
7. One of the listed ports should indicate which port your USB adapter is connected to (e.g. COM1, COM2, COM3, etc.)
8. Go back to firmware loader and make sure it is looking at the correct port.
9. You should be able to transfer data once the correct port is selected

p.s sorry scouser just used your words as it takes a long time to type out.

hope this helps

 

the listed port is com 8 how do i select the correct port on the firmware loader thanks for replying

 

i figured it out thanks alot for the help

 

hello i put the latest firmware on the ev last night but the same thing is happening again, channels are alright for a while but then the level,quility goes down to 8% and the picture breaks up and then no signal, if you turn it off for a while the level-quility goes back up then back down anyone have any solutions for this.

 

make sure the box is connected to the main stream without a spliter or somewhere esle in the house.if this dont work there might be a problem with the feed you are gettin from your prvider..however if your nets workin fine without a prob there might be a prob with your box itself so contact the pperson who sold it to you.

cheers