Eurovox New Software Released.Tested and Working.

I reloaded the 18/04 download onto the box and started from scratch.

All sorted now!!!

Cheers

 

It's 8 slots, i'm a bit color blind so checked with the misses, she says it's a grey colour. So it's a red then??!!??

Is this the file for me so....
UFL_Max_RED_21_04_08.zip

 

Hi my Eurovox is black with silver buttons and says Max 5 on it does this come in a Blue or Red version?

 

your eurovox is a max v so you will need 18/04 ufl maxv kuro 3
dont forger to download your cdf file to put back on after flash do factory reset on it and then put the cdf file back on it works every time for mee! good luck....ps make sure ya max v isnt a clone

 

can any 1 tell me if you can flash a nt* box so we can get it for free view

 

IF you have an origional providers box you should get all freeview channels wether you subsctribe to your provider or not. On my providers box i get BBC& ITV and a few others that are on freeview

I assume thats what your saying or are you asking of you can get all channels on the providers box for free? if so then i think the answer is no and you need a cable box - try the big auctions site commonly known asfeebay

 

ya my box is an old nt* box and i heard that you can flash them has any 1 heard about this ??????

 

You can glitch them but we are not allowed to discuss CC boxes here sorry.

 

I hear you, and have tried 18/04 ufl maxv kuro 3 but I get the message "firmware is not fit for your receiver" I'm pretty sure its a max 5 and that it's not a clone(I got it from the affordable sat website)

 

i ve flashed my box with the red software and done a scan < but its still coming up with searching for codes any ideas?

 

Y CANT U POST CODES ANYMORE

 

how come the time is right for once

 

I have the Eurovox Max V 2008 box and am with N*L Dublin.
Annoyed with inputting codes manually I followed the steps I found on this website to update my firmware.

I tried UFL_MaxV_Kuro3_18_04_08 but encountered whay I think is the "8% problem" and then tried UFL_MaxV_Kuro3_28_04_08.
Unfortunately that didnt fix the problem.

Instead of before where the box recognised the channels but I couldnt watch them now the box says its getting no signal.

Does anybody know what the problem is and how to fix it?

 

If you have no signal it is likely to be a connection problem,check all you connections.

 

Its definetly properly connected

 

did you do a power scan start 290.000 and stop 403.000 and symbol rate 6887 to get all your channels back

 

Yes.

I connected my laptop to the eurovox box. It detected it properly (Version 2.10)
From the menue I reset factory default settings and did a powerscan.

When it finished the powerscan the first time I had no channels. I had an 8% progress bar.

First I reran the 18_04_08 again and then again at a different symbol rate. Then I ran the 28_04_08 UFL because I thought I had the 8% signal problem.

It goes through the powerscan, and appears to be scanning successfully, but when finished I have no channels.

Im worried that something went wrong during my first attempt that may have damaged the box.
On my first attempt I began a powerscan and it was progressing away for about an hour when my flatmate noticed there was a prompt "press ok to begin" so he did, and a different screen (the one Im familiar with) appeared and it did a power scan. Did he inturrupt something that was meant to happen?

 

no i dont think you damaged it ... right look down in the link at the end of my post where it says max v clone or not and make sure you have a genuine box