1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Flash Gone Wrong on Hitachi 79FL

Discussion in 'Xbox - Hardware mods' started by gedders20, Jun 22, 2009.

Thread Status:
Not open for further replies.
  1. gedders20

    gedders20 Member

    Joined:
    Jun 22, 2009
    Messages:
    2
    Likes Received:
    0
    Trophy Points:
    11
    I set about flashing a hitachi drive out of a mates xbox so it will work on mine. I set it into mode b using slax. Then used jungle flasher 1.62 BETA. I followed the instructions on dumping, flashing then rebooting. I used the RAM Upload method and could only set it to use Win API instead of Port IO. It went through the flash and it all said that it was fine and i got confirmation message on the log. I then disconnected my drive from the sata cable and plugged in the 360 SATA. When i insert a disc it says the disc needs to be played on an xbox (same message i got before). Can anybody tell me where i went wrong.
     
  2. creaky

    creaky Moderator Staff Member

    Joined:
    Jan 14, 2005
    Messages:
    31,683
    Likes Received:
    1
    Trophy Points:
    96
    Please look/post in the xbox 360 forum
     
Thread Status:
Not open for further replies.

Share This Page