How to: Update Eurovox Max V with Kuro 18.04.08 (R.I.P 28/11/2008)

Thanks Fergusrb, There was no service to the house when I moved in and the box worked fine then. Why would this be?

 

yes it was there from the previous tenant and was just overlooked for disconnection and once you took out the trial period for their services and then canceled it that is when they disconnected the feed going to the house

If you had just plugged your box in to the cable without them coming out you would have been alright

So now you need to get back on to them and take out a basic subscription with them so you can get your box up and running a little lesson to be learned here dont ask for trial period subscriptions if you have a live feed

 

Does the cable go into a box outside your house. if it does ckeck to see if the cable is connected to the point where you plug your cable inside the house.(they may of disconected it this what happpened to me.)

 

Cheers Rozesky, a friend told me to check the point outside and they had disconnected it. 2 mins and a rescan and everything was back on working fine again. Happy days!!

 

Glad to be of some help.

 

hi guys hoping you can help me out. i flashed my mates black eurovox with the software and did a scan. when it finishes i hit the red button to update channels but 'no transponder found' message appears and there doesnt seem to be any channels listed. i have cleared the data and factory default before scanning.
any ideas?

cheers

 

What firmware version did you use and what provider ID did you use? Also presume its a live feed and coax is in Cable In RF port on the back of the EV?

 

mrmull43 - what is the objective of the re - gurgitated posts, if you have a problem or query then by all means ask.

 

sorry but i am still learning and dont know what you mean

 

Ask a question and you may get an answer

 

Just loaded autoroll software 180408 onto my Eurovox Max V, I am in teesside on NTL, tried scanning on 6.887 symbol rate although not 100% sure this is correct, still getting no channels, 0000 displaying on screen, any ideas?

 

Have you done a powerscan?

 

Halfway through one but doesn't look good, nothing found so far (500/770), now pretty sure 6887 is correct as I have checked my Starview and it is picking up channels ok with this setting, any other ideas?

 

If not try 6952 as you could be on either. But predominantly 6887 for your area. Make sure you have it scanning directly from the incoming feed. And you are in the Cable In RF socket on the back of the box.

 

Thanks guys, now sorted, kind of embarassed to admit I had the cable in the ant instead of RF (cheers scouser), doh!!
sorted now, thanks again

 

No problem, it happens