1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

I screwed up big time...

Discussion in 'Xbox - Hardware mods' started by CSHoffie, Oct 26, 2010.

  1. CSHoffie

    CSHoffie Member

    Joined:
    Oct 26, 2010
    Messages:
    1
    Likes Received:
    0
    Trophy Points:
    11
    Ok, so I was trying to mod my Lite on 93450c and everything was going well until I screwed up...
    [​IMG]

    I accidentally soldered my solder braid to it and I was trying to get it off (re heating the solder, etc) but reheating it wasn't working very well, so I figured it wasn't but a TINY ball of solder anyway so it must not have a good connection... well it did. As you can see when I pulled it off (and I wasn't pulling too hard mind you) a nice big chunk of the copper did too.

    Is there ANY WAY to fix this? I want all options even if it'll be hard or not have a good chance at fixing it. I'm willing to try ANYTHING and everything. Or am I SOL? If I am SOL, then where can I buy a new 93450c or just the controller board? Also, if I do need to replace the drive, has this affected me getting the drive key from this drive to add the new one? Do I need the key for this 93450c if I replaced the drive with a 93450c?

    Sorry for the many questions, I'm just a TAD concerned. Thanks for all your help with this. Much appreciated.
     
  2. infam0us

    infam0us Regular member

    Joined:
    Oct 23, 2005
    Messages:
    1,538
    Likes Received:
    0
    Trophy Points:
    46

Share This Page